The free beta is open. Apply to try the program →
Evolventix
Sheet 3 · verification report

Calculations are re-measured with independent methods.

Verification does not use the program's own formula: the test “cuts” the gear with a rack, turns the pair and measures the backlash, reads Wk with a virtual caliper and compares the result with the calculated value. This page is the readable form of the verification matrix, updated with each release. Verification does not mean the program works without error in every case.

STEP 1

Generates

The program calculates the gear's profile and dimensions from the module, tooth count and profile shift.

STEP 2

Measures

A separately written simulation finds the same gear again: it rolls the basic rack over the gear, turns the pinion and measures the backlash. It does not use the program's formulas.

STEP 3

Compares

If the deviation between the two results exceeds the limit written in the test, the test fails. In geometry tests the limits are mostly below a micrometre.

Matrix · version 10.0 beta

Status of 105 items.

89✓ VerifiedThe calculation was found again with an independent method, deviation within the limit.
6◐ PartialThere is a test, but the source or scope is incomplete.
10○ Not yetThe calculation either does not exist or is not verified; a source document is awaited.

What does this report not say?

The program does not claim to carry an ISO or DIN certificate of conformity. “Verified” means the calculation was found again with an independent method and the deviation stayed within the written limit. Purchased standard texts are not published here. The strength calculation is a preliminary screening; responsibility for the real load, material and lubrication conditions lies with the user.

Try it yourself. A classic hand calculation: for z = 20, m = 1 the span over three teeth is W3 = 7.6604 mm. Enter the same values in the calculator; you should see the same result.

Open the calculator