The free beta is open. Apply to try the program →
Evolventix
Sheet 4 · guides

Guides

Questions asked in the workshop and at the drawing board; with measurements, formulas and examples. Each article has a calculation box where you can enter your own values.

01 · MEASURING AND IDENTIFYING · 4 MIN

How do you find a gear's module?

You have a gear whose module is unknown. A caliper and the tooth count are enough: find the module with one of three methods and round it to the standard value.

02 · DESIGN · 4 MIN

What is undercut, and when does it happen?

On a gear with few teeth the cutting tool digs into the flank at the tooth root. Find with a single formula at which tooth count it happens, and cure it with profile shift.

03 · DESIGN · 5 MIN

What is profile shift for?

You move the cutting tool slightly away from the gear: the tooth gets thicker, undercut goes away, and the centre distance of a pair becomes adjustable.

04 · MEASURING AND IDENTIFYING · 5 MIN

How do you take the span measurement Wk?

You cannot measure tooth thickness directly with a caliper. Wk, measured over several teeth, gives it indirectly and independently of the gear centre.

05 · DESIGN · 4 MIN

What is the minimum contact ratio?

The contact ratio tells how many tooth pairs touch at the same time on average during running. Below 1 the mesh breaks off, below 1.2 it is noisy.

VIDEO · 13 × 35 S

Video tips

Thirteen short videos from module to internal gear: each explains one idea with drawings and shows its counterpart in the program.