What is Wk?
It is the measurement you take with the flat jaws of a caliper over k teeth, resting them on two opposite flanks. The jaws touch the flanks along a tangent to the base circle; so the measurement does not depend on the gear's centre or tip diameter. When the tooth thickness changes, Wk changes too, and you can rely on it.
How is it taken?
- Choose k. At a 20° pressure angle k ≈ z ÷ 9 + 0.5, rounded to the nearest whole number. If it comes out exactly .5, take the smaller one. For z = 24, 24 ÷ 9 + 0.5 = 3.17 → k = 3.
- Rest the jaws. The jaws must touch the opposite flanks of the k teeth. If they touch the corner of the tip or the root, k is wrong.
- Read and repeat. Measure at three or four places around the gear. If the readings differ noticeably, there is a pitch or runout error.
Formula
z = 20, m = 1, x = 0, k = 3.
W₃ = 0.93969·(π·2.5 + 20·0.014904) = 0.93969·(7.85398 + 0.29808) = 7.6604 mm
Profile shift adds a term: 2·x·m·sin α. On a gear with z = 24, m = 2 mm, W₃ is 15.433 mm at x = 0 and 16.117 mm at x = +0.5; the difference is 0.684 mm.
Try it · span measurement
What does it tell you about tooth thickness?
If the tooth thickness in the normal section drops by ΔS, Wk drops by ΔS·cos α. So a tooth 0.10 mm thinner means Wk drops by about 0.094 mm.
That is why you answer “how much deeper should I cut?” with Wk. If the reading is ΔW above the target, feed the tool deeper by Δr = ΔW ÷ (2·sin α); at 20°, Δr ≈ 1.46·ΔW. The finish check in the program does this calculation for you.
Three traps
- Wrong k. If k is too large the jaws touch the tips, if too small the roots; the reading is then not a flank measurement. The calculator chooses the k for which the contact lies on the usable involute, closest to the reference circle.
- Tilted caliper. Hold the caliper perpendicular to the gear axis. If you tilt it, the jaws touch points farther apart and the reading comes out too large.
- Helical gear. The formula is written with the normal module mn and normal pressure angle αn, and z·inv αt is used: Wk = mn·cos αn·[π·(k − 0.5) + z·inv αt] + 2·x·mn·sin αn. The face width must be large enough for the jaws to fit. The program calculates this for you.
See the Wk of your own gear in the calculator with a drawing; compare it with your caliper reading.
Open the calculator