The free beta is open. Apply to try the program →
Evolventix
Sheet 4 · guide 02 · design · ≈ 4 min

What is undercut, and when does it happen?

On a gear with few teeth the cutting tool digs into the flank at the tooth root. Find with a single formula at which tooth count it happens, and cure it with profile shift.

What happens?

A gear is cut with a rack-shaped tool (cutter or hob). If the tooth count is small, the tip of the tool goes below the base circle where the involute starts and also cuts away material at the root of the tooth. This is called undercut. It has three consequences:

  1. The root is weakened. The tooth root gets thinner; the root stress that breaks teeth increases.
  2. The usable flank gets shorter. There is no involute flank left in the cut-away area.
  3. Interference becomes a risk. If the tip of the mating gear touches that area, the mesh is disturbed.

The limit: fewer than how many teeth?

With the standard rack (ISO 53 Type A, 20°, addendum 1·m) the smallest profile shift without undercut is:

xmin = 1 − z·sin²α ÷ 2for α = 20°, xmin = 1 − 0.0585·z (the program also accounts for the tool tip radius; the difference is 0.00003)

For x = 0 this means z ≥ 2 ÷ sin²α = 17.1; the classic “17 teeth” rule comes from here. The program gives a blocker when x < xmin − 0.01; that is why x = 0 is accepted at z = 17 (xmin = +0.006).

zxminfor x = 0
8+0.532undercut
10+0.415undercut
12+0.298undercut
14+0.181undercut
16+0.064undercut
17+0.006at the limit; the program accepts it
18−0.053none
20−0.170none
102030400.50.0-0.5-1.0 z = 17.1 undercut no undercut number of teeth z x
Figure 1. The smallest profile shift without undercut, xmin, falls as the tooth count rises. In the (orange) region below the line the tool cuts away the root of the tooth.

Try it · undercut limit

How is it cured?

  1. Profile shift. Choose x ≥ xmin. For z = 12, x ≥ +0.298; x = +0.30 is enough. The tip diameter grows too: for m = 2 mm, da goes from 28.0 mm to 29.2 mm. The Fix button in the calculator suggests a suitable x.
  2. More teeth. To keep the same diameter, reduce the module and increase z.
  3. A larger pressure angle. For α = 25° the limit drops to about 11–12 teeth (2 ÷ sin²25° = 11.2). But the cutting tool and the mating gear must both be 25° too.

But do not shift too much

Positive x makes the tooth tip thinner. For z = 12, x = +0.30 the tip thickness is 0.44·m. The program warns below 0.4·m and gives a blocker below 0.2·m; on gears to be hardened a thin tip is brittle. For the limits of shift in both directions see the profile shift article.

See for yourself: drag the tooth count below 17 in the calculator. An undercut warning appears and the Fix button suggests a suitable x.

Open with z = 12