The free beta is open. Apply to try the program →
Evolventix
Sheet 2 · gear calculator

Bevel gear calculator

A straight bevel gear pair on intersecting shafts. Dimensions are given at the outer (large) end of the tooth; the addenda are shifted in favour of the pinion by the Gleason method.

Values

Pressure angle 20°, ISO 53 basic rack, no profile shift. Change a value and the results update at once.

Technical drawing · drawn with your values

Results · bevel gear

Pinion pitch cone angle δ₁
26.565 °
Gear pitch cone angle δ₂
63.435 °
Reference diameter d₁
60.000 mm
Reference diameter d₂
120.000 mm
Tip diameter da1
67.218 mm
Tip diameter da2
121.758 mm
Outer cone distance Re
67.082 mm
Suggested maximum face width b
22.361 mm
Pinion addendum shift x₁
0.345
Tooth depth h
6.615 mm
Virtual tooth count zv1
22.36
Virtual tooth count zv2
89.44
Gear ratio i
2.000
Contact ratio εα
1.632

Results are for the initial values; they update when you change the values.

Bevel gear formulas

Example: m 3, z₁ 20, z₂ 40, Σ 90 (the page's initial values). Figures from the program's calculation core.
QuantityFormulaExample
Pitch cone angletan δ₁ = sin Σ / (z₂ / z₁ + cos Σ), δ₂ = Σ − δ₁26.565 °
Reference diameterd = m · z60.000 mm
Outer cone distanceRe = d₁ / (2 · sin δ₁)67.082 mm
Addendum shiftx₁ = 0.46 · (1 − 1 / u′), u′ = z₂ · cos δ₁ / (z₁ · cos δ₂)0.345
Tip diameterda = d + 2 · (1 ± x₁) · m · cos δ67.218 mm
Tooth depthh = 2.188 · m + 0.051 mm6.615 mm
Suggested face widthb ≤ Re / 3 and b ≤ 10 · m22.361 mm
Virtual tooth countzv = z / cos δ22.36

What you should know

The shaft angle is usually 90°; then tan δ₁ = z₁ / z₂.

The face width should not exceed a third of the cone distance; the inner end of the tooth gets thinner towards the cone apex and carries no load.

The virtual tooth count zv is used for undercut and strength: in this example a 20-tooth bevel pinion behaves like a 22-tooth spur gear.

Video tip

Tip #12: Bevel gear. When the shaft turns 90°: cone angles and the apex.
TIP #12 · 35 sBevel gearWhen the shaft turns 90°: cone angles and the apex.
All video tips →

Design this gear with profile shift in the program; get undercut and interference checks, strength, technical drawing, 3D model and STEP / DXF output.

Apply for the free beta