The free beta is open. Apply to try the program →
Evolventix
Sheet 2 · gear calculator

Which gear have I measured?

You have a gear with no drawing. Count its teeth, measure the tip diameter with a caliper and the span over k and k + 1 teeth with a gear tooth micrometer; the page scans the standard metric module and inch (DP) series and pressure angles such as 20°, 14.5° and 25°, and ranks the gears that best fit the measurements.

Measurements

The tip diameter alone is not enough: Wk and Wk+1 determine the pressure angle and profile shift. Their difference is the base pitch (pb = π m cos α); the module and pressure angle come from it, the profile shift from Wk and the tip shortening from the tip diameter. A field left empty is not used. The page address carries your measurements.

Technical drawing · most likely candidate (spur gear)

Candidates · most likely at the top

Enter the measurements; candidates are listed at once.

How it is found

The profile shift is found separately for each standard module and pressure angle; the candidate most consistent with the measurements gets the lowest score.
QuantityFormulaNote
Base pitchpb = Wk+1 − Wk = π · mn · cos αnmodule and α
x, from the W measurementx = [Wk − m cos αn((k − 0.5)π + z inv αt)] / (2 m sin αn)most reliable
x, from the tip diameterx = (da / m − z / cos β − 2) / 2comes out small if the tip is shortened
x, from the root diameterx = (df / m − z / cos β + 2.5) / 2rough check
Suggested kk ≈ zn · α / 180° + 0.5; zn = z / cos³βmeasurement near the reference circle
DP → modulem = 25.4 / DPinch gears

When measuring

Take the W measurement with a gear tooth micrometer (disc anvils); the discs should touch the teeth around the reference circle. First measure Wk with the suggested k, then Wk+1 over one more tooth.

On a worn gear the tooth thickness is smaller and the profile shift comes out a little low. The base pitch is little affected by wear; the module and pressure angle are still found reliably.

On a helical gear W is measured in the normal plane; if you do not know the helix angle, measure it from the mating gear or from the tooth trace. The result is a suggestion: on a critical part, check the mesh with the mating gear.

Design the gear you found in the program; get undercut and interference checks, strength, technical drawing, 3D model and STEP / DXF output.

Apply for the free beta