Roller chain sprocket calculator
ISO 606 roller chain sprocket: A (ANSI) and B (European) series chains, 1–3 strands. Enter the other sprocket to get the number of links and the centre distance; with power and speed, see whether the chain carries the load.
Results · chain sprocket
- Pitch diameter d
- — mm
- Tip diameter da
- — mm
- Root diameter df
- — mm
- Measurement over rollers MR
- — mm
- Largest hub diameter dg
- — mm
- Tooth width bf
- — mm
- Seating radius ri
- — mm
- Flank radius re
- — mm
- Roller seating angle α
- — °
Results · chain drive
- Number of links X
- —
- Centre distance a
- — mm
- Ratio i
- —
- Wrap on the small sprocket
- — °
- Chain speed v
- — m/s
- Lubrication (suggested)
- —
- Power the chain carries
- — kW
- Design power P·Ks
- — kW
- Power safety
- —
- Static safety S
- —
- Chain pull Ft
- — N
Results for the first values; they update when you change the values.
Roller chain sprocket formulas
| Quantity | Formula | Example |
|---|---|---|
| Pitch diameter | d = p / sin(180° / z) | 69.116 mm |
| Tip diameter | da = d + p·(1 − 1.6 / z) − d₁ … d + 1.25·p − d₁ | 74.875 mm |
| Root diameter | df = d − d₁ | 60.606 mm |
| Over rollers | MR = d·cos(90° / z) + d₁ (odd z), d + d₁ (even z) | 77.331 mm |
| Seating radius | ri = 0.505·d₁ … 0.505·d₁ + 0.069·∛d₁ | 4.368 mm |
| Number of links | X = 2a / p + (z₁ + z₂) / 2 + p / a · ((z₂ − z₁) / 2π)², rounded up to even | 114 |
| Centre distance | a = p / 4 · (A + √(A² − 8B²)), A = X − (z₁ + z₂) / 2, B = (z₂ − z₁) / 2π | 503.308 mm |
| Chain speed | v = z₁ · p · n₁ / 60 000 | 5.22 m/s |
| Rated power | the smaller of link plate fatigue and roller-bush impact (ANSI equations) | 5.70 kW |
| Static safety | S = Fu / (Ks·Ft + q·v²) | 17.5 |
Good to know
The number of links should be even; an odd number needs an offset link and weakens the chain. The centre distance you enter is rounded to an even number of links, so it changes a little: the nearest options are under the results, changing the other sprocket by a few teeth included.
At least 17 teeth are recommended on the small sprocket; with fewer, the polygon effect makes the chain speed fluctuate. The large sprocket should stay under 120 teeth, the centre distance at 30–50 pitches and the wrap on the small sprocket at 120° or more.
The power ratings come from the ANSI chain equations for about 15,000 hours with proper lubrication; for the B series they are an estimate by pitch, and the maker's table comes first.
Design the sprocket in the program with its ISO 606 chain links: both sprockets and the closed chain of a drive, 3D motion, technical drawing, shop card and STEP output.
Apply for the free beta